Emblaze-VCON VCB5 Betriebsanweisung PDF herunterladen (Seite 15)

2 Defining the VCB IP Configuration

Emblaze-VCON Guide 9

2.3) Assigning a Static IP Address to the VCB

through interface GbE0

This procedure describes how to set static IP Address while connecting to Factory

Default GbE0.

1 Connect a crossover cable between interface GbE0 and a computer.

This interface’s IP configuration is:

1 To access the VCB unit from another computer initially, the two systems

must, at least temporarily, belong to the same network segment. That is,

the first three fields of the address and the subnet mask must be identical.

Write down the computer’s current IP address and subnet mask so that you

can restore them later.

Change the remote computer’s IP configuration temporarily to the same IP

address segment(10.0.10.x) and subnet mask listed in step 1.

2 On the computer, open web browse and in the address field, enter the

VCB’s IP address.

3 EVC Home page loads. Click on the EVCAdmin section.

4 Enter login name and password. Default name is su and default password

is 1234.

5 Under the VCB tab, click on Network.

6 A list of all network interfaces is displayed.

7 Select NIC interface. Click on its name to open the configuration page.

IP address 10.0.10.10

Subnet mask 255.255.0.0

Gateway IP

address

0.0.0.0

Connect to GbE0.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 69 70

Keine Kommentare

Emblaze-VCON VCB5 Betriebsanweisung Seite 15